Envirolite Midalux 230

Envirolite Midalux 230

ATER-BASED ZERO VOC & REDUCED VOC PAINT

All Midas Paints at Midas Paints Tygervalley are rated by our Green Filter to give you a clear indication of the VOC (Volatile Organic Compounds) and other chemical content. We believe in being transparent and we want to give you healthier, more ethical choices.

Envirolite Midalux 230 – Acrylic finishing coat Satin Paint.

Ultra low sheen durable interior and exterior topcoat with excellent hiding power – washable and wipeable.  Our Envirolite core range of water-based acrylic is graded by number – so sheen levels, washability and durability all increase up the scale.

Midalux 230 Product Description:

An environmentally friendly, easy to apply, superior quality Pure Acrylic finishing coat that dries to a luxurious satin finish.
It has been formulated to offer excellent hiding power and washability and is suitable for use as a luxurious interior coating or a durable exterior coating. Midalux 230 product conforms to GBCSA environmental requirements and EU 2010 targets.

Envirolite Midalux 230

Envirolite Midalux 230

Benefits of Midalux 230

Interiors & exteriors
Topcoat
Superior wipeability & washability
Not available in deep colours

Area of Use of Midas 230

Interior and exterior surfaces.
Used as a finishing coat on suitably primed new, or previously painted sand/cement plaster, concrete, fairfaced brickwork and gypsum plaster. Also suitable for primed asbestos and fibre cement.
NOTE: Refer to the occupational health & safety act 1993 (ACT NO.85 of 1993) ASBESTOS REGULATIONS, 2001; for working with asbestos fibre products.

Application of  Midalux 230

PLEASE NOTE: Correct preparation is essential. All surfaces must be sound and prepared in the recommended manner.
For more information on surface preparation contact Midas Paints Tygervalley Store.
After the correct surface preparation has been completed apply the necessary primer coat.
Then thoroughly stir and apply a minimum of 2 coats of Midalux 230 to prepared surfaces using a brush, roller or spray at the stipulated spread rates.
Allow to dry before over-coating.
Pure Acrylic finishing coat satin finish.

IMPORTANT: Walls (cement plaster, concrete or masonry) must be dry before painting and should not exceed a moisture content of 10% as measured with a Midas Paints Tygervalley Moisture Meter or equal. The ambient temperature must not be below 10ºC and not higher than 35ºC.
Humidity must not be below 10% and not higher than 85%.
· Excessive application thickness and/or rapid drying could lead to mud cracking.
· Always keep a wet edge and avoid downing tools during the application process to prevent lap marks and variances in colour or texture. Work from corner to corner, or from a natural cut off point to another.
Do not attempt touch ups, but redo complete panels.

Downloads:
Midalux 230 Technical Data Sheet

Related Products:
Related Products:
Envirolite Midalux 240
Envirolite Midafelt 220
Envirolite Midamax 200
Envirolite Midamax 190

Pin It on Pinterest

Share This